W283

Warning lamps

catalogue number click and see the details	cable / wires	light source	mounting side	operating voltage	warning light	amber light	blue light	red light	blue lens	transparent lens	synchronization	pieces in the box
2463	24cm	LED	Universal	12V-24V								100
2464	24cm	LED	Universal	12V-24V								100
2464 KR	24cm	LED	Universal	12V-24V								100
2465	24cm	LED	Universal	12V-24V								100

1. If you plan to install several lamps and synchronise them with each other, make sure that only one of them is connected as the ‘MASTER’. NOTE Only lamps of the same type and with the same number of patterns can be synchronised.
2. The Master, Slave function of the lamp is selected by connecting the white wire for the MASTER lamp or the yellow wire for the SLAVE lamp respectively to the (-) power supply of the vehicle.
3. The change of the synchronisation method to flashing in counter-phase is only possible to set in the SLAVE lamp(s), but without connection to the MASTER circuit.During operation of the SLAVE lamp(s), the white colour lead should be shorted to (-) of the power supply for about 5 seconds. The change will be confirmed by skipping one series of flashes. Shorting the white lead to (-) of the power supply again in SLAVE mode will set the lamp to synchronise in phase. All SLAVE lamps for which the phase of operation is to be changed can be switched together.
4. To change the pattern, short-circuit the synchronisation line for approximately 1 second to the (+) of the power supply. The MASTER lamp enforces the pattern number on the SLAVE lamps.

index	power consumption	light source	programs
index	power consumption	light source	numbers	type
2463	8 W	12 LED	5	I, II, III, IV, V
2464	10 W	12 LED	2	I, IV
2464 KR	10 W	12 LED	4	I, II, IV, V
2465	8 W	12 LED	5	I, II, III, IV, V

Click and see the details

CALL

W283